FREE UK SHIPPING!   Tel: 01902 581 301  Mon-Fri  9am-5pm
Six String Supplies — Audio or Linear Pots?

Audio or Linear Pots?


Guitar pots fall into two taper categories – audio and linear. This describes the point of resistance as the pot is turned. For example, a linear pot has a more uniform taper – when the pot is turned to its halfway point of the cycle (50%), it will reach 50% of its total resistance. Hence the name, linear. It is based on a uniform line, scale and taper. If it is turned to 25% of its cycle, then it will have a resistance reading of 25% and so on.

Audio pots on the other hand will increase/decrease most of its resistance in the final 50% of its rotation. So which one is better and which guitars use linear or audio? It is down to personal preference. The problem with linear pots is that the human ear does not work in the same way. So whilst the resistance reading will be 50% when it is turned half way, our ears will interpret it differently. The easiest way to demonstrate this is to increase and decrease the volume on a radio or your TV. The volume increase from 10-20 is a lot greater than that from 0-10. Despite being equal amounts of volume increase, the difference between the two is unequal. This is why audio pots were invented - to compensate for the fact that hunman hearing doesn't work in algorithm form. When both pots are turned all the down, the resistance will be 0% of its stated value and when both pots are fully opened the resistance will be 100% of its stated value. The difference between the two is the levels as they are being rotated.

There is no general rule of thumb with guitar electronics. Many imported models will use audio (marked A500K/A250K) for volume controls and linear (marked B500K/B250K) for tone. Fender tend to use audio pots for both volume and tone. Gibson have chopped and changed over the years. Epiphone use linear for volume and audio for tone but they too have changed and reversed this so that they use audio for volume and linear for tone. Bottom line – choose what is best suited to you. Linear pots will give a uniform decrease in volume/tone (you will notice more of an effect on each control knob setting) whilst audio will give a more instant (quicker) increase or decrease in volume or tone. If you gig a lot, audio may be better for a quicker boost while on stage.

Share

Guitar Wiring FAQ

250k or 500k Pots?

Treble Bleed Mod

Modern vs 50s Les Paul Wiring